I Lose Internet Connection When Uploading 192.168.2.1 Update
This Article Applies to:
You may refer to the Video first:
Precondition: Brand sure Cyberspace works fine if you lot connect the computer straight to the modem,past pass the TP-Link router.
Problem Description:
At that place is no internet access after installing the TP-Link Router and there is no WAN IP Accost on the router's status page.
Note:If you are not sure how to log into the router's web interface to check the WAN IP Address ,delight click here.
Solution 1 ： Cheque the Concrete connection betwixt the modem and the router.
If you see a ruby message "WAN Port is unplugged" on the status page of the router,that means the modem is NOT plugged into the WAN Port of the router properly.Please plug it in and make sure the reddish message will exist gone.
Solution two ： Clone the MAC address of your PC.
Some Isp will register the MAC address of your calculator when you access the Internet for the start time through their Cablevision modem , if yous add a router into your network to share your Internet connection, the ISP volition non accept information technology as the MAC address is inverse, and so we need to clone your estimator's MAC address to the router.
one) Make certain that you lot are continued to the TP-Link Router with the computer that was originally connected to your Cable modem, then log on to the management clickNetwork->MAC Clone on the left side.
2. Click Clone MAC Address,this role will clone your PC's MAC accost to WAN MAC Address of the router.
Solution 3 : Change the LAN IP address of the router.
Virtually TP-Link routers utilize 192.168.1.1 /192.168.0.1 as their default LAN IP accost, it may be alien with the IP range of your real ADSL modem /router . If so,the router is not able to communicate with your modem and cause you can't admission the Internet. To resolve the trouble, we need to change the LAN IP address of the router to aviod such disharmonize, for example, 192.168.ii.ane.
ClickNetwork->LAN in the left side card, and then alter the IP Address to another ane (for example, 192.168.two.one), then click "Save".
Notation: after you changed the LAN IP address, side by side time you lot need to apply the new IP accost to access the router'due south management page and renew a IP address for your computer
Solution 4 :Ability Cycle Modem and Router .
TP-Link routers tin can Plug&Play with most modems, but sometimes we need to do a "Ability Cycle" to re-institute the connection:
1) Power off your modem and TP-Link router, leave them off for 1 minute;
ii) Ability on your Router first
3) Ability back on your modem, await well-nigh 2 minutes until it get a solid cable or Internet light;
4) Look some other i or ii minutes and cheque the Net admission.
Solution 5: Double check the WAN Connexion Blazon.
ane) Refer to this link for guidance of choosing correct WAN Connection Type of the router.Contact your ISP for suggestion if necessary.
2) ClickNetwork->WANin the left menu to configure the correctWAN Connection Type -> Save.
three.Power cycle the modem and the router once again.
If the router gets WAN IP address from the modem but still can non get internet ,please refer to :
Is this faq useful?
Your feedback helps meliorate this site.
Source: https://www.tp-link.com/us/support/faq/138/
0 Response to "I Lose Internet Connection When Uploading 192.168.2.1 Update"
Post a Comment